*力叉车电瓶采用密封式吸液技术设计的结果，使它能以低维护量工作，比普通的铅酸叉车蓄电池更加*。但是，叉车蓄电池如在不正常的工作条件下，或由于损坏、错误使用，则有可能出现危险的状况，产生酸雾和电解液的渗漏。因此，在使用*力叉车蓄电池时，请严格遵守安装手册内的建议及守则。整体电池组串联电压很高，重量也很沉，因此安装时，对固定蓄电池箱体的起*线要注意分离，避免接触蓄电池单体*柱短路。*力叉车电瓶每天工作完后，注意检查液体是否足量，正负*柱线是否松动；在充电过程中，记得检查充电电压及充电电流是否*合叉车的充电标准，这样能避免蓄电池在充电造成的过度充电；一般蓄电池充电充电电流为蓄电池组容量的十分之一，如：48V400AH*力叉车蓄电池，充电电流应为40安以下，充电电压高于48V以上。目前Jungheinrich*力叉车电瓶主要分为两大类：158宽VBS和198宽PZS牵引用铅酸蓄电池系列；采用*的优质聚丙烯蓄电池槽、盖、*电瓶的耐冲击性能；蓄电池组是由铅和铅的氧化物构成，电解液是*的水溶液。JUNGHEINRICH forklift battery uses a sealed suction technology design results, enabling it to low maintenance work, than ordinary lead-acid battery forklift battery more secure. However, forklift battery as in normal working conditions, or the result of a damaged, wrong use, there may be a dangerous situation, produce mist and electrolyte leakage. Therefore, in the use of JUNGHEINRICH forklift battery, please strictly observe installation manual within the suggestion and code. The whole battery series voltage is high, weight is very heavy, so the installation of stationary battery box, the line to the attention of separation, to avoid contact with battery monomer pole circuit. JUNGHEINRICH forklift batteries every day after work, pay attention to check whether enough liquid, positive and negative pole line is loose; in the process of charging, remember to check the charging voltage and charging current is in accordance with the forklift charging standard, this can avoid battery in charging caused by excessive charging; general battery charging current for the battery group capacity1/10, such as:48V400AH JUNGHEINRICH forklift battery, charging current should be40the following, charging voltage above 48V. The current Jungheinrich JUNGHEINRICH forklift batteries are mainly divided into two categories:158VBS wide and 198PZS wide lead-acid traction batteries series; imported high quality pol*ropylene battery slot cover, battery, ensure the impact resistance performance; storage battery group is composed of lead and lead oxide, electrolytic solution is a solution of water.
