江淮叉车电瓶系列*大充电电流不应该*过蓄电池组安时数C10的10%（如400安电池组，*大充电电流应该不*过40安）。环境温度每升高1度，充电电压降低0.003V/单体，环境温度每降低1度，充电电压升高0.0003V/单体。注意：每组48VJAC叉车蓄电池组包含24个单体，每组24V电池组包含12个单体，每组80V电瓶组包含40个单体。浮充电压对蓄电池的使用寿命有直接影响，高于推荐*限的浮充电压会降低蓄电池在JAC叉车上的使用寿命。低于推荐的浮充电压会导致蓄电池组的容量不足。江淮叉车蓄电池采用*的合金配方，使用高纯度多元铅基合金，使板栅具有良好耐腐性能，析气量小，水损耗低，自放电小。在使用江淮叉车电瓶时，请严格遵守安装手册内的建议及守则。整体电池组串联电压很高，重量也很沉，因此安装时，对固定蓄电池箱体的起*线要注意分离，避免接触蓄电池单体*柱短路。叉车蓄电池每天工作完后，注意检查液体是否足量，正负*柱线是否松动；在充电过程中，记得检查充电电压及充电电流是否*合叉车的充电标准，这样能避免蓄电池在充电造成的过度充电；现可配套江淮叉车蓄电池的车型有：CPD10、CPD15、CPD20、CPD25、CPD30。Jianghuai forklifts battery series maximum charging current should not exceed C10battery ampere hour number10% ( such as400battery, charging current should not exceed 40. ). For every increase of environmental temperature1 degrees, charging voltage to reduce 0.003V/ monomer, environment temperature every1 degrees lower, charging voltage increases0.0003V/ monomer. Note: each48VJAC forklift battery contains 24 monomers, n = 24V battery contains 12 monomers, n = 80V battery group contains 40monomer. Floating voltage on the service life of the battery has a direct impact, above the recommended limit floating charge voltage will decrease the battery at JAC forklift service life. Below the recommended float voltage will cause the battery capacity is insufficient. Jianghuai forklifts battery using advanced alloy formula, using high purity multiple lead based alloy, so that the grid has good corrosion resistance, *all water gas evolution, low loss, *all self-discharge. In the use of Jianghuai forklifts battery, please strictly observe installation manual within the suggestion and code. The whole battery series voltage is high, weight is very heavy, so the installation of stationary battery box, the line to the attention of separation, to avoid contact with battery monomer pole circuit. Forklift batteries every day after work, pay attention to check whether enough liquid, positive and negative pole line is loose; in the process of charging, remember to check the charging voltage and charging current is in accordance with the forklift charging standard, this can avoid battery in charging caused by excessive charging; now supporting the Jianghuai forklifts battery models are: CPD10, CPD15, CPD20, CPD25, CPD30.
