图文详情
产品属性
相关推荐
configured in a Von-Neumann architecture. Code memory, data memory, registers and I/O ports are organized within the same linear address space of
16M Byte. The entire memory space can be accessed Bytewise or Wordwise. Particular portions of the on-chip memory have additionally been made
directly bit addressable.ROM : 32K Byte of on-chip ROM.RAM : 2K Byte of on-chip internal RAM (dual-port) is provided as a storage for data, system stack, general purpose register banks andcode. The register bank can consist of up to 16
wordwide (R0 to R15) and/or Bytewide (RL0,RH0, …, RL7, RH7) general purpose registers.XRAM : 2K Byte of on-chip extension RAM (single port XRAM) is provided as a storage for data,user stack and code.
The XRAM is connected to the internal XBUS and is accessed like an external memory in 16-bit demultiplexed bus-mode without waitstate or read/write delay (80ns access at 25MHz CPUclock). Byte and Word access is allowed.The XRAM address range is 00’E000h -00’E7FFh if the XRAM is enabled (XPEN bit 2 of
SYSCON register). As the XRAM appears like external memory, it cannot be used for the ST10R167’s system stack or register banks. The XRAM is not provided for single bit storage and therefore is not bit addressable. If bit XRAMEN is cleared, then any access in the address range 00’E000h - 00’E7FFh will be directed to external memory interface, using the BUSCONx register corresponding to address matching ADDRSELx register.
SFR/*FR : 1024 Byte (2 * 512 Byte) of address space is reserved for the special function register areas. SFRs are wordwide registers which are used for controlling and monitoring functions of the different on-chip units. CAN : Address range 00’EF00h - 00’EFFFh is reserved for the CAN Module access. The CAN is
enabled by setting XPEN bit 2 of the SYSCON register. Accesses to the CAN Module use demultiplexed addresses and a 16-bit data bus (Byteaccesses are possible). Two wait states give an access time of 160ns at 25MHz CPU clock. No
tristate waitstate is used. Note If the CAN module is used, Port 4 can not
be programmed to output all 8 segment address lines. Thus, only 4 segment
address lines can be used, reducing the external memory space to 5M Byte (1M
Byte per CS line).
In order to meet the needs of designs where more memory is required than is provided on chip, up to 16M Byte of external RAM and/or ROM can be
connected to the microcontroller.