供应台湾松瀚单片机SN8P2501B DIP14

1.1 FEATUR*
♦  Memory configuration  ♦  Three interrupt sources
  OTP ROM size: 1K * 16 bits.    One internal interrupts: T0, TC0.
  RAM size: 48 * 8 bits.    One external interrupts: INT0.
  Four levels stack buffer    
   ♦  Two 8-bit Timer/Counter
♦  I/O pin configuration    T0: Basic Timer with 0.5sec RTC.
  Bi-directional: P0, P1, P2, P5.    TC0: Auto-reload timer/Counter/Buzzer output
  Input only: P1.1.    
  Programmable open-drain: P1.0.  ♦  On chip watchdog timer and clock source is internal  
  Wakeup: P0, P1 level change trigger    low clock RC t*e (16KHz @3V, 32KHz @5V).
  Pull-up resisters: P0, P1, P2, P5.    
  External Interrupt trigger edge:  ♦  Dual system clocks
    P0.0 controlled by PEDGE register.    External high clock: RC t*e up to 10 MHz
      External high clock: Crystal t*e up to 16 MHz
♦  3-Level LVD.    Internal high clock: 16MHz RC t*e.
  Reset system and power monitor.    Internal low clock: RC t*e 16KHz(3V), 32KHz(5V)
    
♦  Powerful instructions  ♦  Operating modes
  One clocks per instruction cycle (1T)    Normal mode: Both high and low clock active
  Most of instructions are one cycle only.    Slow mode: Low clock only
  All ROM area JMP instruction.    Sleep mode: Both high and low clock s*
  All ROM area CALL address instruction.    Green mode: Periodical wakeup by T0 Timer
  All ROM area lookup table function (MOVC)    
   ♦  Package (Chip form support)
      PDIP 14 pins
      SOP 14 pins
      SSOP 16 pins