LMIX1的安装位置*须远离干扰源0.5m以上。常见干扰源为：电流接触器、继电器、电机、电闸、控制器等等。LMIX2读头引出的数据线*须和机台相关的电源线分离，尽量远离干扰源，以减少输过程中的干扰。

l        供电电压

供电电压*须为稳定的直流电源，5V供电时电压变化范围小于&plu*n;2.5%。5V和30V供电时，允许的杂波范围是：小于50mV。

l        故障清除

倘若按照如上所介绍的注意事项操作后，仍然有问题，请按照如下方法处理：

直流电源部分，添加RC器件（例如：0.1µF/100Ω）。

直流电感，添加二*管处理。

电机相位和电机刹车部分，添加RC器件。

不同系统尽量使用分离电源，例如（控制器、数显等等分别供电）。

l      01 - Supply voltage / level 10 - 30 VDC / 5 V-TTL- line driver

公差/供电电压                                                         ：稳定，波动*大5 %

消耗                                                                              ：Max. 150 mA

输出频率                                                                  ：100 kHz (per channel A or B)

操作速度                                                                  ：Max. 10 m/s

*大线长                                                                  ：50 m

l      11 - Supply voltage / level 5 VDC / 5 V-TTL- line driver

公差/供电电压                                                         ：&plu*n;2.5%,波动小于50mV

消耗                                                                              ：Max. 200 mA

输出频率                                                                  ：100 kHz (per channel A or B)

操作速度                                                                  ：Max. 10 m/s

*大线长                                                                  ：10 m

l      Technical specifications * 20.50 (accessories)

磁间距                                                                       ：5 mm

操作温度                                                                           ：0－60°C

精度（at 20° C in mm）                                     ：&plu*n; (0.025 0.02 x L)/L:effective measuring length in m

长度膨胀系数                                                             ：16 x 10^－61/K

弯曲半径                                                                           ：*小150 mm

保护等级                                                                  ：IP65