ANALOG DEVICES - ADG715BRUZ - 芯片 八模拟开关 SPST

芯片 八模拟开关 SPST

模拟开关类型: SPST
通道数: 8
带宽: 155MHz
通态电阻, R on 最大: 4.5ohm
时间, t off: 85ns
时间, t on: 95ns
电源电压范围: 2.7V 到 5.5V
工作温度范围: -40°C 到 +85°C
封装类型: TSSOP
针脚数: 24
SVHC(高度关注物质): No SVHC (19-Dec-2011)
器件标号: 715
在电阻RDS（上）: 2.5ohm
封装类型: 剥式
封装类型: TSSOP
工作温度敏: -40°C
工作温度最高: 85°C
开关数: 8
接口类型: I2C
电源电压: 单
电源电压 最大: 5.5V
电源电压 最小: 2.7V
芯片标号: 715
表面安装器件: 表面安装
通态电阻: 2.5ohm

通态电阻, Rds on
最大: 4.5ohm

GENERAL DESCRIPTION
The ADG714/ADG715 are CMOS, octal SPST (single-pole,
single-throw) switches controlled via either a 2- or 3-wire serial
interface. On resistance is closely matched between switches and
very flat over the full signal range. Each switch conducts equally
well in both directions and the input signal range extends to the
supplies. Data is written to these devices in the form of 8 bits,
each bit corresponding to one channel.
The ADG714 uses a 3-wire serial interface that is compatible
with SPI , QSPI, and MICROWIRE and most DSP interface
standards. The output of the shift register DOUT enables a
number of these parts to be daisy chained.
The ADG715 uses a 2-wire serial interface that is compatible
with the I2C interface standard. The ADG715 has four hard wired
addresses, selectable from two external address pins (A0 and A1).
This allows the 2 LSBs of the 7-bit slave address to be set by
the user. A maximum of four of these devices may be connected
to the bus.