900223 APEM法国进口操纵杆、电位器式操纵杆现货

保护等级IP65以上面板密封。

NOTES
1. BEZEL OPTIONS
For drop in mounting, please specify bezel option 6 or 7. For sub-panel mounting, no bezel is necessary, unless the boot is
required to seal to the front face of the panel in which case bezel option 4 should be specified. Bezels 6 & 7 clamp the boot
and top face of the joystick body to the panel whereas bezel 4 clamps only the boot.
2. SPRINGING
As standard 9000 Series are offered sprung to centre. The standard spring force requires 1.3N (nominally) to off-center the
joystick. The 9000 Series may be specified with a lighter spring (1N), or a stronger spring (1.6N)
Note: Forces quoted are subject to exact joystick configuration and are provided as a guide only.
3. DUAL DECODE INTERFACE
For optimum performance of the center detect and fault detect signals, Apem recommends the signals are “pulled high” via
an input resistor of typically 22k, on the controller circuitry.
4. CENTER TAP REFERENCE
All 9000 Series output a center tap reference as standard. This reference is set within the joystick at 50% of Vcc (+/-1%).
For optimum accuracy the outputs should be read relative to the center tap.
5. NON STANDARD
Further non standard options including custom handles or special limiters are available. Please refer to the factory for
further details.