供应 LM3S2139-IQC25-A2 TI进口MUC芯片

The Stellaris® LM3S2139 microcontroller is based on the ARM® Cortex™-M3 controller core operating at up to 25 MHz, with 64 kB flash and 16 kB SRAM. The LM3S2139 also features real-time industrial connectivity, with a CAN controller, an SSI / SPI controller, an I2C interface, and 2 UARTs. The microcontroller also features intelligent analog capability, including 3 analog comparators and 4 channels of highly accurate 10-bit analog-to-digital conversion - with the ability to sample at speeds of 250K samples per second. Finally, the LM3S2139 microcontroller provides a 24-bit systick timer, 3 32-bit or 6 16-bit general-purpose timers, a watchdog timer, a low drop-out voltage regulator so that only one supply voltage is required, brown-out reset, power-on reset controller, and up to 56 GPIOs.

特性

32-bit ARM® Cortex™-M3 25-MHz processor core with System Timer (SysTick), integrated Nested Vectored Interrupt Controller (NVIC), Memory Protection Unit (MPU), and Thumb-2 instruction set

Full-featured debug solution with debug access via JTAG and Serial Wire interfaces, and IEEE 1149.1-1990 compliant Test Access Port (TAP) controller

64 KB single-cycle flash and 16 KB single-cycle SRAM

26-56 GPIOs (depending on configuration) with programmable control for GPIO interrupts and pad configuration

ARM FiRM-compliant Watchdog Timer ; plus three General-Purpose Timer Modules (GPTM), each of which provides two 16-bit timers/counters and can be configured to operate independently

10-bit Analog-to-Digital Converter (ADC) with four analog input channels and a sample rate of 250 thousand samples/second

Two fully programmable 16C550-type UARTs with IrDA support

Synchronous Serial Interface (SSI), supporting operation for Freescale SPI, MICROWIRE, or Texas Instruments synchronous serial interfaces

Inter-Integrated Circuit (I2C) Interface, providing Standard (100 Kbps) and Fast (400 Kbps) transmission and support for sending and receiving data as either a master or a slave

Controller Area Network (CAN) Interface using CAN protocol version 2.0 part A/B and with bit rates up to 1 Mbps

Three integrated analog comparators configurable for output to initiate an ADC sample sequence, drive an output pin or generate an interrupt

Industrial and extended temperature RoHS-compliant 100-pin LQFP package and industrial-range RoHS-compliant 108-ball BGA package

规格

产品属性 属性值 搜索类似

制造商: Texas Instruments 

产品种类: ARM微控制器 - MCU 

RoHS:  详细信息  

安装风格: SMD/SMT 

封装 / 箱体: LQFP-100 

系列: LM3S2139 

核心: ARM Cortex M3 

数据总线宽度: 32 bit 

最大时钟频率: 25 MHz 

程序存储器大小: 64 kB 

数据 RAM 大小: 16 kB 

ADC分辨率: 10 bit 

输入/输出端数量: 56 I/O 

工作电源电压: 2.5 V 

最小工作温度: - 40 C 

最大工作温度: + 85 C 

接口类型: CAN, I2C, SPI, SSI, UART 

封装: Tube 

高度: 1.4 mm  

长度: 14 mm  

产品: MCU  

程序存储器类型: Flash  

宽度: 14 mm  

商标: Texas Instruments  

模拟电源电压: 3.3 V  

I/O 电压: 3.3 V  

ADC通道数量: 4  

计时器/计数器数量: 5 Timer  

处理器系列: Stellaris  

工厂包装数量: 90  

电源电压-最大: 2.75 V  

电源电压-最小: 2.25 V  

商标名: Stelaris  

单位重量: 1.319 g