TPS73625DBVR 低压差稳压器TI德州仪器原装

1 Features 3 Description

The TPS736xx family of low-dropout (LDO) linear

1• Stable with No Output Capacitor or Any Value or

voltage regulators uses a new topology: an NMOS Type of Capacitor

pass element in a voltage-follower configuration. This

• Input Voltage Range of 1.7 V to 5.5 V topology is stable using output capacitors with low

• Ultra-Low Dropout Voltage: 75 mV typ ESR, and even allows operation without a capacitor.

• Excellent Load Transient Response—with or It also provides high reverse blockage (low reverse

without Optional Output Capacitor current) and ground pin current that is nearly constant

over all values of output current.

• New NMOS Topology Delivers Low Reverse

Leakage Current The TPS736xx uses an advanced BiCMOS process

to yield high precision while delivering very low • Low Noise: 30 μVRMS typ (10 Hz to 100 kHz) dropout voltages and low ground pin current. Current

• 0.5% Initial Accuracy consumption, when not enabled, is under 1 μA and

• 1% Overall Accuracy Over Line, Load, and ideal for portable applications. The extremely low

Temperature output noise (30 μVRMS with 0.1-μF CNR) is ideal for

powering VCOs. These devices are protected by • Less Than 1 μA max IQ in Shutdown Mode thermal shutdown and foldback current limit.

• Thermal Shutdown and Specified Min/Max

Current Limit Protection Device Information(1)

2 Applications the end of the datasheet.

• Portable/Battery-Powered Equipment

• Post-Regulation for Switching Supplies

• Noise-Sensitive Circuitry such as VCOs

• Point of Load Regulation for DSPs, FPGAs,

ASICs, and Microprocessors
TPS73625DBVR TPS73625DBVR TPS73625DBVRTPS73625DBVR

1特征3描述

TPS736xx家族的低辍学率(LDO)线性

1•稳定无输出电容或任何值或

电压调节器采用了一种新的拓扑结构:一种NMOS类型的电容器

在电压跟随器配置中传递元件。这

•使用低电压的输出电容，1.7 V到5.5 V的输入电压范围是稳定的

•超低电压:75 mV typ ESR，甚至不需要电容就可以工作。

•良好的负载瞬态响应——带有或它也提供了高的反向堵塞(低反向)

没有可选的输出电容电流)和接近恒定的接地针电流

输出电流的所有值。

•新的NMOS拓扑提供低反转

泄漏电流TPS736xx采用先进的BiCMOS工艺

产生高精度而交付•低噪音非常低:30μVRMS typ(10赫兹至100千赫)辍学电压和低地面销电流。当前的

•消费初始精度0.5%,未启用时,正在1μA中

•1%的整体精度超过线，负载，和理想的便携式应用程序。极低的

0.1温度输出噪声(30μVRMS -μf CNR)是理想的

驱动配装。这些设备保护•马克斯智商小于1μA关闭模式热停堆和返送电流限制。

•热关闭，并指定最小/最大

电流限制保护装置信息(1)

应用程序数据表的末尾。

•便携式/电池供电设备

•开关电源的后监管

•噪音敏感电路，如VCOs

•DSPs、FPGAs的负载调节点，

asic和微处理器