**原装板24V2.5A/60W电源适配器

地区:广东 深圳
认证:

陈春茂

普通会员

全部产品 进入商铺

**原装板24V2.5A/60W电源适配器  

 

1、输入特性(INPUT CHARA*ERISTICS): 

  1.1输入电压(Input Voltage):

    额定电压(Nominal Voltage):100-240Vac

     调整范围(Variation Range:90-264Vac

  1.2输入频率(Input Frequency:

    额定频率(Nominal Frequency:50/60Hz

    调整频率(Variation Frequency:47-63Hz

 1.3输入电流(Input Current):

   当输入交流电压为额定值的下限时,输出电压负载满载,*大输入交流电流1A

    1Arms max At any input voltage and rated, DC output rated load.

 1.4浪涌电流(Inrush Current):

   当输出为额定负载,环境温度为25,输入240Vac冷态起动电源时的*大浪涌电流 小于30A

   30Amps Max. Cold start at 240Vac input, with rated load and 25ambient.

1.5 AC漏电流(Ac Leakage Current):

当输入电压240Vac时,*大漏电流为0.25mA

2、输出特性(OUTPUT CHARA*ERISTICS):

2.1输出功率(Power Output);

     电压      *小负载    *大负载     输出功率

    Voltage      Min. Load     Max. Load    Output Power

      24Vdc        0A         3.0A           72W

2.2负载特性/调整率(Combined Load/Line Regulation):

     电压  *小空载电压 *大空载电压     线性调整     负载调整

    Voltage  Min. Voltage    Max. Voltage     Line Regulation   Load Regulation

    24.0Vdc    23.4V        24.6V          &plu*n;3%           &plu*n;5%

2.3波纹和噪音(Ripple And Noise:

测试条件:任何负载正常工作下,使用示波器带宽为20MHz连接到充电器的输出端,同时输出端并连一个47uF的电解电容和一个0.1uF的瓷片电容。

    The ripple and noise are as follows when measure with Max. Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point.

 

                电压           *大波纹*大噪音

               Voltage          Ripple And Noise(Max.)

24.0Vdc            100mVp-p

 

2.4启动延迟时间(Turn On Delay Time):

     当输入115Vac和输出*大负载时,*大启动时间为2S

      2 second Max. At 115Vac input and output Max. Load.

2.5上升时间(Rise Time):

     当输入115Vac和输出*大负载时*大时间为40mS

      40mS Max. At 115Vac input and output Max. Load.

2.6保持时间(Hold Up Time):

     当输入115V和输出*大负载时,*小保持时间为5mS

      5mS Min. At 115Vac input and output Max. Load.

2.7效率(Efficiency):

     当输入100Vac和输出*大负载时,*小80%

      80%Min.At 100Vac input and output Max. Load.

     当输入240Vac和输出*大负载时,*小85%

      85%Min.At 240Vac input and output Max. Load.

2.8过冲(Overshoot):

     在电源开启或关闭的时候,*大15%

      15%Max.When power supply at turn on or turn off.

3、保护功能(PROTE*ION REQUIREMENT):

3.1短路电路保护:

      Short Circuit Protection:

     该电源供给器在短路解除时,能正常工作恢复。

The power supply will be auto recovered when short circuit faults remove.

3.2过流保护(Over current Protection):过流故障排除后,电源将自动恢复正常工作。

      The power supply will be auto recovered when over current faults remove.

3.3过压保护(Over Voltage Protection)

     当输出电压*过额定电压时,电源将保护,故障排除后不能恢复正常工作。

The power supply will not be auto recovered when faults remove.

4、环境要求(ENVIRONMENTAL REQUIREMET):

4.1工作温度(Operating Temperature):

     0~ -40,满载,正常工作(Full load Normal operation)

    0to40,Full load Normal operation.

4.2存温度(Storage Temperature):-20to85,带外壳(With package).

4.3工作湿度(Relative Humidity):

      5%(0)90%(40),72小时,满载,正常工作

      5%(0)90%(40)RH,72Hrs,Full load Normal operating.

4.4振(Vibration):

      1、测试标准:国际电工电子委员会  Operating: IEC 721-3-3 3M3

          59Hz,A=1.5mm加速度(9200Hz,Acceleration 5m/s2                                                                                                                                                                                                                                       

           2、运输(Transportation):IEC 721-3-2 2M2

          5-9HzA=3.5mm

          9200Hz,加速度Acceleration=5m/S2

          200500HZ,加速度Acceleration=15m/S2

      3、轴向振动(Axes,10 cycles per axis.

         在测试过程中不能出现永久性的损坏。

No permanent damage may occur during testing.

在电源开启和关闭后,样机能够恢复到*初条件。

 The product has to restors its original situation after power off/on.)

4.5跌落试验(Dropping)(Packed):

 一个角,三个棱,六个面。

1 corner,3 edges, and 6 surfaces

高度76cm  Height:76cm

5、*及EMC要求(SAFETY AND EMC REQUIREMENT):

5.1*:*合CE UL标准

5.2高压(DIELE*RIC STRENGTH)(H-Pot)

    (Primary to secondary),3000Vac/5mA/60s.

6、结构参数(MECHANICAL REQUIREMENT)

  6.1外壳(Enclosure):

    外形尺寸:112mm(长)*50mm(宽)*30mm(厚)

   The power supply size L:112*W:50*H:30mm

    重量:232g

6.2输入线(Input Connector):

    2*0.5欧规插头线长1.2m  (2*0.5 input wire 1.2m)

6.3;输出线

DC线: AWM  2464  20AWG*2C,VW-1,80,FTI,300V,线上有字,1.2米圆线带磁环

DC头尺寸为5.5*2.5*10mm.DC头为内正外负。

    DC cable: AWM 2464  20AWG*2CVW-180℃,FTI300Vwith word on the

cord, Length:1.8M,DC plug 5.5*2.5*10mm. in /out-

 

实物拍照图:









 

品牌/商标

英文中性标签

型号/规格

24V2.5A

适用产品

电子设备

输入电压范围

AC100-240V

输出电压

DC24V

OEM

可OEM