图文详情
产品属性
相关推荐
ETA4553DCI 电子元器件 ETA 封装DFN1.4x1.0-8L 批次22+
2位双向电压级转换器,适用于开式漏极和推挽式应用
DESCRIPTION
ETA4553, two-bit non-inverting translator, is a bidirectional voltage-level translator and can be used to establish digital switching compatibility between mixed-voltage systems. It uses two separate configurable power-supply rails, with the A ports supporting operating voltages from 1.65V to 5.5V while it tracks the VCCA supply, and the B ports supporting operating voltages from 2.3V to 5.5V while it tracks the VCCB supply. This allows the support of both lower and higher logic signal levels while providing bidirectional translation capabilities between any of the 1.8V, 2.5V, 3.3V, and 5V voltage nodes.
ETA4553 provide enable control pin, OE. When the output-enable (OE) input is low, all I/Os are placed in the high-impedance state, which significantly reduces the power-supply quiescent current consumption. OE has an internal pull-down current source, as long as VCCA is powered.
To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pull-down resistor, the minimum value of the resistor is determined by the current-sourcing capability of the driver.
FEATURES
No Direction-Control Signal Needed
Data Rates
24Mbps (Push-Pull)
2Mbps (Open-Drain)
1.65V to 5.5V on A Ports and 2.3V to 5.5V on B Ports (VCCA ≤ VCCB)
VCC Isolation: If Either VCC is at GND, Both Ports are in the High-Impedance State
No Power-Supply Sequencing Required: Either VCCA or VCCB can be Ramped First
IOFF: Supports Partial-Power-Down Mode Operation
Available in Green DFN1.4x1.0-8L Package
APPLICATIONS
I2C/SMBus
UART
GPIO
ETA4553DCI
ETA(钰泰)
DFN1.4x1.0-8L
22+
中国