STM32F101CBT6Features
■ Core: ARM 32-bit Cortex?-M3
CPU
– 36 MHz maximum frequency,
1.25 DMIPS/MHz (Dhrystone 2.1)
performance at 0 wait state memory
access
– Single-cycle multiplication and hardware
division
■ Memories
– 64 to 128 Kbytes of Flash memory
– 10 to 16 Kbytes of SRAM
■ Clock, reset and supply management
– 2.0 to 3.6 V application supply and I/Os
– POR, PDR and programmable voltage
detector (PVD)
– 4-to-16 MHz crystal oscillator
– Internal 8 MHz factory-trimmed RC
– Internal 40 kHz RC
– PLL for CPU clock
– 32 kHz oscillator for RTC with calibration
■ Low power
– Sleep, Stop and Standby modes
– VBAT supply for RTC and backup registers
■ Debug mode
– Serial wire debug (SWD) and JTAG
interfaces
■ DMA
– 7-channel DMA controller
– Peripherals supported: timers, ADC, SPIs,
I
2Cs and USARTs
■ 1 × 12-bit, 1 μs A/D converter (up to 16
channels)
– Conversion range: 0 to 3.6 V
– Temperature sensor
■ Up to 80 fast I/O ports
– 26/37/51/80 I/Os, all mappable on 16
external interrupt vectors and almost all
5 V-tolerant
■ Six timers
– Three 16-bit timers, each with up to 4
IC/OC/PWM or pulse counter
– 2 watchdog timers (Independent and
Window)
– SysTick timer: 24-bit downcounter
■ Up to 7 communication interfaces
– Up to 2 x I2C interfaces (SMBus/PMBus)
– Up to 3 USARTs (ISO 7816 interface, LIN,
IrDA capability, modem control)
– Up to 2 SPIs (18 Mbit/s)
■ CRC calculation unit, 96-bit unique ID
■ ECOPACK? packages
STM32F101CBT6Description
The STM32F101xB and STM32F101x8 medium-density access line family incorporates the
high-performance ARM Cortex?-M3 32-bit RISC core operating at a 36 MHz frequency,
high-speed embedded memories (Flash memory up to 128 Kbytes and SRAM up to 16
Kbytes), and an extensive range of enhanced peripherals and I/Os connected to two APB
buses. All devices offer standard communication interfaces (two I2Cs, two SPIs, and up to
three USARTs), one 12-bit ADC and three general-purpose 16-bit timers.
The STM32F101xx medium-density access line family operates in the –40 to +85 °C
temperature range, from a 2.0 to 3.6 V power supply. A comprehensive set of power-saving
mode allows the design of low-power applications.
The STM32F101xx medium-density access line family includes devices in four different
packages ranging from 36 pins to 100 pins. Depending on the device chosen, different sets
of peripherals are included, the description below gives an overview of the complete range
of peripherals proposed in this family.
These features make the STM32F101xx medium-density access line microcontroller family
suitable for a wide range of applications:
● Application control and user interface
● Medical and handheld equipment
● PC peripherals, gaming and GPS platforms
● Industrial applications: PLC, inverters, printers, and scanners
● Alarm systems, Video intercom, and HVAC
STM32F101CBT6制造接入线路,基于arm的32位单片机与64或128 KB的Flash,6个计时器,ADC和7通信接口
STM32F101CBT6特性
■核心:手臂32位皮层m3 CPU
- 36 MHz频率最大,1.25 DMIPS / MHz(Dhrystone 2.1)在0等待状态内存访问性能
- 单循环乘法和硬件部门
■记忆
- 64到128 kb的闪存
- 10到16 k字节的存储器
■时钟、复位和供应管理
- 2.0到3.6 V应用供应和I / o
- 穷,PDR和可编程电压检测器(PVD)
- 日MHz晶体振荡器内部8 MHz factory-trimmed RC
- 内部40 kHz RC
- CPU时钟
- 32 kHz振荡器的锁相环RTC校准
■低功率
- 睡眠,停止和待机模式
- VBAT供应RTC和备份寄存器
■调试模式
- 串行线调试(门限和通过JTAG接口
■直接存储器存取
- 7通道DMA控制器
-外设支持:计时器,ADC,spi,我2 cs和,
■1×12位,1μs A / D转换器(16通道)
- 转换范围:0到3.6 V
-温度传感器
■80快速I / O端口
- 26/37/51/80 I / Os,所有可用图表示的外部中断向量和几乎所有5 V-tolerant
■6个计时器
三个16位定时器,每个4个IC / OC / PWM脉冲计数器
- 2看门狗定时器(独立和窗口)
- SysTick计时器:24位downcounter
■7通信接口
- 2 x I2C接口(SMBus / PMBus)
3,(ISO 7816接口,林,红外线功能,现代控制)
- 2 spi(18 Mbit / s)
■CRC计算单元,96位的惟一ID
■ECOPACK包
STM32F101CBT6产品描述
STM32F101xB和STM32F101x8制造访问行家庭包含高性能ARM皮质?m3 32位RISC核心操作以36 MHz的频率,高速嵌入式记忆(闪存128 kb和SRAM 16 k字节),和一个广泛范围的增强的外设和I / o连接到两个APB总线。所有设备提供标准通信接口(两个i2c,两个spi,三,),一个12位ADC和三个通用的16位定时器。
STM32F101xx制造访问行家庭经营在-40 + 85°C温度范围从2.0到3.6 V电源。一组全面的节电模式允许低功耗的设计应用程序。
STM32F101xx制造家庭接入线路包括设备在四个不同的包从36针100针。取决于所选择的设备,不同的外围设备,包含下面的描述概述外围设备提出了完整的家庭。
这些特性使STM32F101xx制造接入线路单片机家庭适用于广泛的应用:
●医疗应用程序控制和用户界面
●手持设备
●PC外围设备,游戏和GPS平台
●工业应用:PLC、变频器、打印机、扫描仪
●报警系统、视频对讲,空调
