ATSAM3S2BA-AU MCU Microchip

地区:广东 深圳
认证:

深圳市中立信电子科技有限公司

金牌会员16年

全部产品 进入商铺

ATSAM3S2BA-AU

ARM微控制器 - MCU MRL A 128K Flash 32K SRAM Ind Temp


Description ATSAM3S2BA-AU

Atmel's ATSAM3S2BA-AU SAM3S series is a member of a family of 32-bit Flash microcontrollers based on the high performance ARM Cortex-M3 processor. It operates at a maximum speed of 64 MHz and features up to 256 Kbytes of Flash and up to 48 Kbytes of SRAM. 


Features ATSAM3S2BA-AU

• Core

– ARM® Cortex®-M3 revision 2.0 running at up to 64 MHz

– Memory Protection Unit (MPU)

– Thumb®-2 instruction set

• Pin-to-pin compatible with AT91SAM7S series (48- and 64-pin versions)

• Peripherals

– USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints. On-Chip Transceiver

– Up to 2 USARTs with ISO7816, IrDA®, RS-485, SPI, Manchester and Modem Mode

– Two 2-wire UARTs

– Up to 2 Two Wire Interface (I2C compatible), 1 SPI, 1 Serial Synchronous Controller (I2S), 1 High Speed Multimedia Card

Interface (SDIO/SD Card/MMC)

– Up to 6 Three-Channel 16-bit Timer/Counter with capture, waveform, compare and PWM mode. Quadrature Decoder

Logic and 2-bit Gray Up/Down Counter for Stepper Motor

– 4-channel 16-bit PWM with Complementary Output, Fault Input, 12-bit Dead Time Generator Counter for Motor Control

– 32-bit Real-time Timer and RTC with calendar and alarm features

– Up to 15-channel, 1Msps ADC with differential input mode and programmable gain stage

– One 2-channel 12-bit 1Msps DAC

– One Analog Comparator with flexible input selection, Selectable input hysteresis

– 32-bit Cyclic Redundancy Check Calculation Unit (CRCCU)

– Write Protected Registers

• I/O

– Up to 79 I/O lines with external interrupt capability (edge or level sensitivity), debouncing, glitch filtering and on-die Series Resistor Termination

– Three 32-bit Parallel Input/Output Controllers, Peripheral DMA assisted Parallel Capture Mode

型号/规格

ATSAM3S2BA-AU

品牌/商标

Microchip

内存大小

32位

时钟频率

64 MHz

工作电源电压

1.8 V

程序存储器大小

128 kB

数据 RAM 大小

32 kB