GL850G SSOP28 USB2.0 HUB 台湾创惟正规代理供货规格书Datasheet提供技术支持

FEATURES 

 Compliant to USB Specification Revision 2.0

 Support 4/3/2 downstream ports by I/O pin configuration 

 Upstream port supports both high-speed (HS) and full-speed (FS) traffic 

 Downstream ports support HS, FS, and low-speed (LS) traffic 

 1 control pipe (endpoint 0, 64-byte data payload) and 1 interrupt pipe (endpoint 1, 1-byte data payload) 

 Backward compatible to USB specification Revision 1.1 

 On-chip 8-bit micro-processor 

 RISC-like architecture 

 USB optimized instruction set 

 Performance: 6 MIPS @ 12MHz 

 With 64-byte RAM and 2K mask ROM 

 Support customized PID, VID by reading external EEPROM

 Support downstream port configuration by reading external EEPROM 

 Single Transaction Translator (STT) 

 Single TT shares the same TT control logics for all downstream port devices. This is the most cost effective solution for TT. Multiple TT provides individual TT control logics for each downstream port. This is a performance better choice for USB 2.0 hub. Please refer to GL852G datasheet for more detailed information. 

 Integrate USB 2.0 transceiver 

 Built-in upstream 1.5KΩ pull-up and downstream 15KΩ pull-down  Embed serial resister for USB signals 

 Conform to bus power requirements 

 Automatic switching between self-powered and bus-powered modes 

 Support compound-device (non-removable in downstream ports) by I/O pin configuration 

 Configurable non-removable device support 

 Built-in PLL supports external 12 MHz crystal / Oscillator clock input  Built-in 5V to 3.3V regulator 

 Low power consumption

 Improve output drivers with slew-rate control for EMI reduction 

 Internal power-fail detection for ESD recovery 

 ESD protection up to 4KV of HBM by MIL-STD-883H standard on all USB pins. 

 Each downstream port supports two-color status indicator, with automatic and manual modes compliant to USB specification Revision 2.0 (Not available for SSOP 28 package) 

 Support both individual and gang modes of power management and over-current detection for downstream ports (Individual mode is not supported by SSOP 28 package) 

 Power enable pin supports both low/high-enabled power switches. (Power switch is not supported by GL850G-22 SSOP28 package) 

 Optional 27/48 MHz Oscillator clock input (Not available for QFN28 / SSOP28 package) 

 Number of Downstream port can be configured by GPIO without external EEPROM 

 Available package type: 48 pin LQFP, 28 pin QFN and 28 pin SSOP (Full Function only available in 48 pin) 

 Applications: 

 Stand-alone USB hub 

 PC motherboard USB hub, Docking of notebook 

 Gaming console