图文详情
产品属性
相关推荐
1.Scope(适用范围)
ZACN0103A是我公司开发的一款100~240Vac电压输入的隔离LED恒流驱动电源,采用高转换效率、工作稳定、低损耗的开关控制芯片,使用性能优良的元器件,具有低噪声、*、*、长寿命等特点。本产品主要用蜡烛灯内置电源
2.Electrical Characteristic(电气特性)
2.1Rated input Voltage(额定输入电压)
It is normal for 100Vac to 240Vac AC input voltage.
(额定输入交流100V-240V)
2.2Input Voltage Range(输入电压范围)
The charger shall operate from 100Vac to 264Vac and the range switching is unnecessary.
(输入电压范围交流100V~264V)
2.3Rated Frequency(输入额定频率)
It is normal for 50Hz or 60Hz and single phase.
(输入频率50Hz/60Hz)
2.4Frequency Range(输入频率范围)
The charger shall operate with an input frequency from 47 Hz to 63Hz
(输入频率范围47Hz~63Hz)
2.5Steady AC Current(AC输入电流)
Maximum steady state input current is 200mA (Max) Measured at 100Vac input and maximum load.
(100V满载时输入电流200mA(Max))
2.6Peak Inrush Current(峰值输入电流)
With cold starting, the peak inrush current should less than 30A(at 240V test).
(电源启动时*大峰值输入电流小于30A(at 240V test))
2.7Efficiency(效率)
73% min. measured at 110Vac and 240Vac input voltage,maximum load and include the DC cable loss.
(在输入电压110Vac-240Vac,输出*大负荷下,电源工作效率大于73%)
2.8Rated Output Current(额定输出电流)
The output current will be performed from 200mA&plu*n;5% at CV mode
(在CV模式下额定输出电流.200mA&plu*n;5% )
2.9Output Voltage(输出电压)
Full voltage (输出电压):14V~17V
2.10Rated Power(额定功率)
This Charger is capable to support 3Watts Max continuously at all specified conditions.
(不同状态下输出功率在3Watts Max)
2.11Output Ripple and Noise(输出纹波、噪音)
Output ripple voltage is less than 2V p-p(I=200mA) Measured methods:
Performed by 20MHz bandwidth in oscilloscope.
Applied 0.1uF ceramic capacitor and 10uF electrolytic capacitor across output
terminals Measured at the end of out cable,
(输出端并0.1uF与10uF电容,限制示波器带宽20MHz时,测得纹波小于2Vp-p)
2.12Test Circuit(测试电路)
If the test is to be made on a specified circuit,be sure to use the following circuit.
(无*规定的情况下依照下面的电路进行测试)
2.13Output Short Circuit Protection(输出短路保护)
Short circuit occurred on output should not damage to the power supply. The power supply will be automatically recovered.
(输出短路时,电源不会有损坏,故障解除后将会自动恢复正常)
3.Reliability items(信赖性项目)
3.1Mean Time Between Failure(平均无故障时间)
The drives shall be designed and produced to have a mean time between failures(MTBF)of
30000 operating hours ,conditions: at 25℃,nominal input voltage.
Standard:MIL-HDBK-217F
(在25℃正常输入电压时,其平均无故障时间为30000小时)
4.Environmental Requirement(环境要求)
4.1Operating Temperature And Operating Humidity(工作温度和湿度)
0℃~ 65℃ 35~85% RH Non-condensing
4.2Storage Temperature And Storage Humidity(储藏温度和湿度)
-20℃~ 85℃ 5~95% RH. Non-condensing
5.Mechanical Requirement(机械要求)
5.1Dimension(尺寸)
21.5(L)*21(W)*16(H)mm
5.2Weight(重量)
3g
6.Environmental Performances(环境性能)
6.1Operating at the Low temperature(低温工作实验)
At 0&plu*n;2℃(24 hours),with the rated voltage 100-240Vac charged to the primary and unloaded and full load
on the secondary abnormality in electric and mechanical characteristic, after 4 hours recovery
at the room temperature
(环境温度0&plu*n;2℃,在输入端加额定电压100~240Vac输出端无负荷与满载状态下24小时试验,试验后
常温放置4小时,无特性异常)
6.2Operating at the High Temperature(高温工作实验)
At 65&plu*n;2℃(24 hours),with the rated voltage 100-240Vac charged to the primary and unloaded and full load
On the secondary, No abnormality in electric and mechanical characteristic after 4 hours recovery
at the room temperature.
(环境温度65&plu*n;2℃,在输入端施加额定电压100-240Vac输出端无负荷与满载状态下24小时试验,试验后
常温放置4小时,无特性异常)
6.3Storage at the Low Temperature(低温放置)
At -20&plu*n;2℃(24 hours),test of non-operated,No abnormality in electric and mechanical characteristic after 4
hours recovery at the room temperature.
(在-20&plu*n;2℃非工作状态下进行24小时试验,试验后常温放置4小时后测试无异常)
6.4Storage at the High Temperature(高温放置)
At 85&plu*n;2℃(24 hours),test of non-operated,No abnormality in electric and mechanical characteristic after 4
hours recovery at the room temperature.
(85&plu*n;2℃非动作状态下进行24小时试验,试验后常温放置4小时后测试无异常)
6.5Storage at High Temperature and High Humidity with the Adaptor Turned on(通电高温高湿度放置)
At 65℃, 90~95%RH(24 hours),operating at power supplied(100-240Vac) and unloaded and full load on the
Secondary, no abnormality in electric and mechanical characteristic, after 4 hours recovery at the room temperature.
(在65℃, 90~95%RH,加电状态下24小时试验,试验后常温放置4小时测试特性无异常)
6.6Storage at low Temperature and Low Humidity with the Adaptor Turned on(通电低温低湿度放置)
At 0℃, 10%~40%RH(24 hours),operating at power supplied(100-240Vac) and unloaded and full load on the
Secondary, no abnormality in electric and mechanical characteristic, after 4 hours recovery
at the room temperature.
(在0℃, 10%~40%RH,加电状态下24小时试验,试验后常温放置4小时测试特性无异常)
志洲
ZACN0103A
AC/DC电源
脉冲频率调制(PFM)式
推挽式
100-240(V)
3(W)
9-11(V)
72(%)
CE
300mA