The TH8082 is a physical layer device for a single wire data link capable of operating in applications where high data rate is not required and a lower data rate can achieve cost reductions in both the physical media components and in the microprocessor which use the network. The TH8082 is designed in accordance to the physical layer definition of the LIN Protocol Specification, Rev. 1.3.The IC furthermore can be used in ISO9141 systems.

Because of the very low current consumption of the TH8082 in the sleep mode it’s suitable for ECU applications with hard standby current requirements. This mode allows a shutdown of the whole application. The included wake-up function detects incoming dominant bus messages and enables the voltage regulator.

• Operating voltage VS = 6 to 18 V
• Very low standby current consumption of t*. 6.5µA in sleep mode
• LIN-Bus Transceiver:
• Slew rate control for good EMC behavior
• Fully integrated receiver filter
• BUS input voltage -27V to 40V
• Integrated termination resistor for LIN slave nodes (30kOhm)
• Wake up via LIN bus
• Baud rate up to 20 kBaud
• Compliant to LIN Specification 1.3, 2.x and J2602
• Compatible to ISO9141 functions
• Control output for voltage regulator with low on – resistance for switchable master termination
• High EMI immunity
• Bus terminals proof against short-circuits and transients in the automotive environment
• High impedance Bus pin in case of loss of ground and undervoltage condition
• Thermal overload protection
• High signal symmetry for using in RC – based slave nodes up to 2% clock tolerance
• 4kV ESD protection at Bus pin

特点和优点